An Escape Series #1 - The Car Walkthrough

-Examine the console in the bottom middle of the front seat
-Open the lid and take the flashlight
-Turn around to the back seat
-Examine the console in the bottom middle again
-This time you will see the back of the console, the ashtray
-Pull out the lighter and take the small key underneath
-Return to the back seat
-Click the bottom right or bottom left area of the screen to look at the backseat floor
-Examine the floormat on the right and take the knife from underneath
-Return to the backseat
-Click the ceiling area, above the rear window
-Use the knife to remove the wiring guide from the ceiling
-Go to the front seat
-Examine the glove box and use the small key to open it
-Take the batteries and electrical tape
-Combine the batteries and flashlight
-Return to the backseat
-Use the knife to cut the straps on each side of the cushion
-Click the cushion to set it aside
-Click the small dark gray area behind the cushion
-Enter "E40" on the numberpad (this can be seen from examining the instrument panel in the front seat. The E on the gas gauge is circled, and the speedometer is stuck on 40)
-Use the flashlight with batteries to see
-Break the cracked light cover on the left with either the knife, screwdriver, or hammer
-Take the key that falls on the floor
-Return to the front seat
-Examine the pedals underneath the steering wheel
-Use the screwdriver to open the panel underneath the steering wheel
-Following the wiring guide, only connect the red, blue, green, and gray wires. Use the electrical tape on each connection
-Examine the instrument panel behind the steering wheel
-Use the key in the ignition switch to turn the car's electricity on
-Return to the area with the pedals, and press the trunk release button
-Exit through the trunk


Escape The Car